I have a vector I made of a small (2.5 x 4) tribal type design that's failry complex (and a PITA to weed out!). I cut it on a plotter. I need to add a thin pinstripe to the edge. I used the "expand" command and that achomplished what I wanted but it is too thin. I need to "stripe" to be a little thicker. The design is so small I think I will never be able to successfully weed it being that thin.
Is the "expand" amount adjustable? Is there another way to go about it? (I tried "offset path" but that left a mess of lines all over both inside and outside. It would take me forever to clean that up). Since I will be using a plotter the least amount of extraneous lines being added is ideal to lessen my clean up time. I am fairly good with PS but Illustrator, vectors, and Plotters are pretty new to me.